Cub Cadet CC350 Návod k obsluze stáhnout pdf (Strana 6)

Setup and

Adjustment

1. Remove any packing material which may be between

upper and lower handles.

a. Pull up and back on upper handle as shown in

Figure 3-1. Make certain the lower handle is seated

securely into the handle mounting brackets.

b. Tighten hand knobs securing upper handle to

lower handle. Make sure that each carriage bolt is

seated properly in the handle.

2. Locate hairpin clip in one hole on the weld pin on each

side of lower handle.

a. Remove hairpin clip from this hole. Using a pair of

pliers, insert hairpin clip into the other hole on the

weld pin. See Figure 3-2. Repeat on other side.

b. Insert a carriage bolt from the hardware pack into

the upper hole on the handle mounting bracket.

Secure with one plastic wing nut, also included

in the hardware pack. Repeat on other side with

remaining items from hardware pack.

3. The rope guide is attached to the right side of the

upper handle. Loosen the wing nut which secures the

rope guide.

a. Hold the blade control against upper handle.

b. Pull starter rope out of the engine. Release the

blade control. See Figure 3-3.

c. Slip starter rope into rope guide.

d. Tighten wing nut.

4. Insert post on cable ties into holes provided on the

lower handle. Pull cable tie tight and trim excess.

5. An adjusting plate and thumb lever at each wheel

position provides cutting height adjustment.

a. Depress lever towards wheel.

b. Move it to any of the nine positions for desired

cutting height. See Figure 3-4.

c. Release lever towards mower deck.

Figure 3-3

Figure 3-2

NOTE: Stand behind

the mower as if you

were going to operate

it. Your right hand cor-

responds to the right

side of the mower; your

left hand corresponds

to the left side of the

mower.

Figure 3-1

IMPORTANT

This unit is shipped

without gasoline or

oil in the engine. Fill

up gasoline and oil

as instructed in the

accompanying engine

manual BEFORE

operating your mower.

NOTE: Each end of

the lower handle must

be placed in the same

relative position.

Figure 3-4

NOTE: Your mower

is shipped with the

handle in the higher

height position.

IMPORTANT

DO NOT crimp the

cables when lifting the

handle up. Make sure

to route the cables

inside the lower handle.





























1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Cub Cadet CC350 Návod k obsluze Strana 6

Komentáře k této Příručce

Související produkty a manuály pro Zastřihovače trávy Cub Cadet CC350