Cub Cadet 7532 Návod k obsluze Strana 116
- Strana / 126
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
MAINTENANCE/ADJUSTMENTS
108
Rotating fan and belts. Contact can injure. Keep clear.
BRAKE PEDAL ADJUSTMENT
Service Specifications
Brake Pedal Check and Adjustment Interval Every 200 hours or yearly
Free Pedal Movement Specification 35mm (1.4inch)
Brake pedal free play is very important and must be checked at the
recommended intervals. If there is no free movement, the brake shoes will
wear quickly.
If there is too much free movement, accidents may occur. If there is not the
same free movement between LH pedal and RH pedal, it may cause
serious accidents.
Put the tractor on level ground, move the range lever in the L position.
Stop the engine.
Loosen lock nut and rotate the brake
rod to make a free play of 20 to 30 mm
(0.79 to 1.18 in.) at the brake pedal.
With this much play obtained, tighten
the lock nut.
Confirm that the right and left brakes
operate simultaneously by running
the tractor.
If not, adjust both of them by means
of the brake rods.
ADJUSTING NUT
BRAKE
ROD
2020
- OPERATOR’S MANUAL 1
- COMPACT TRACTOR 1
- SERIES 7000 1
- Off-Road Diesel Engine 2
- 1-330-273-4550. The emission 3
- INTRODUCTION 6
- SERIAL NUMBERS 7
- SERIAL NUMBER LOCATIONS 7
- GENERAL TABLE OF CONTENTS 8
- SAFETY PRECAUTIONS 9
- SAFETY/DECALS 10
- 321-6714 16
- Tractor Roll Over 18
- Safety Rules 18
- ROPS Label 18
- Foldable ROPS Frame 19
- Normal Operating Position 19
- Low Clearance Positions 20
- DIESEL ENGINE 22
- POWER TRAIN 23
- Mechanical Front Drive (MFD) 24
- Differential Lock 24
- Steering 24
- Hitch System 24
- Hydraulic System 25
- Rear Power Takeoff (PTO) 25
- INSTRUMENTS AND INDICATORS 27
- INSTRUMENTS/CONTROLS 28
- OPERATING CONTROLS 30
- Control Levers and Pedals 33
- BRAKE PEDAL 35
- Control Levers 37
- OPERATORS SEAT 43
- STEERING COLUMN TILT 43
- BEFORE STARTING THE ENGINE 44
- 5th Hour 45
- NORMAL STARTING PROCEDURE 46
- OPERATING INSTRUCTION 48
- CLUTCH PEDAL 48
- STOPPING THE ENGINE 50
- COLD TEMPERATURE OPERATION 51
- HOW TO TRANSPORT TRACTOR 53
- GEAR DRIVE TRANSMISSION 54
- Transmission Operation 55
- DIFFERENTIAL LOCK 56
- POWER TAKEOFF (PTO) 57
- POWER TAKEOFF GUARDS 59
- PTO OPERATING SAFETY 60
- WARNING LAMPS 62
- REAR PTO SHAFT 63
- SAFETY CHAIN 64
- THREE POINT HITCH SYSTEM 65
- HITCH SYSTEM ADJUSTMENTS 66
- Upper Link 67
- Stabilizer 67
- HITCH OPERATION 68
- Hitch Control Lever 69
- HYDRAULIC BLOCK 71
- FIELD OPERATION 72
- TIRE AND RIM EQUIPMENT 73
- Tire Load Capacity 74
- Check Air Pressure 75
- Tire Inflation Procedure 75
- WHEEL MOUNTING TORQUES 76
- FRONT WHEEL ADJUSTMENT 77
- Toe-in Adjustment 78
- (RH SIDE) 79
- TIRES/WHEELS/SPACING/BALLAST 80
- TIRE SIZE COMBINATIONS-MFD 81
- TRACTOR BALLAST 82
- BONNETBONNET 84
- PROP ROD 84
- Lubrication Table 85
- SERVICE HOUR INTERVAL 86
- Service After First 50 Hours 87
- SYSTEM CAPACITIES 88
- LUBRICATION/FILTERS/FLUIDS 89
- ENGINE LUBRICATION 92
- Engine Oil Level 92
- Engine Oil Change 93
- Engine Oil Filter 94
- Coolant Solutions 96
- Cleaning The Cooling System 97
- FUEL SYSTEM 98
- Diesel Fuel Specifications 99
- Specifications For Acceptable 99
- Number Two Diesel Fuel 99
- FUEL SHUT-OFF VALVE 100
- RETAINING NUT 100
- FILTER ELEMENT 100
- Fuel System Air Removal 101
- INJECTION PUMP 102
- AIR INDUCTION SYSTEM 103
- Air Filter Element Removal 104
- Element Cleaning 105
- System Inspection 105
- Service Specifications 106
- Transmission Oil Level 106
- (Gear Drive) 106
- (Hydrostatic Drive) 106
- Transmission Oil Change 107
- LUBRICATION/FILTERS/FRUIDS 108
- HYDRAULIC FILTER 108
- FRONT AXLE LUBRICATION (MFD) 110
- Front Axle Oil Change 111
- COOLING SYSTEM 112
- Fan Belt Adjustment 113
- Fan Belt Replacement 114
- CLUTCH PEDAL ADJUSTMENT 115
- BRAKE PEDAL ADJUSTMENT 116
- RAISE STOP SETTING POSITION 117
- SPECIFICATIONS 118
- GENERAL SERVICE INFORMATION 119
- ELECTRICAL SYSTEM 120
- Line Fuse 121
- Auxiliary Battery Connections 122
- Battery Cables and Terminals 123
- When Charging the Battery 124
- When Battery Is Not in Use 124
- STORING THE TRACTOR 125
- REMOVING FROM STORAGE 126
Související produkty a manuály pro Traktor Cub Cadet 7532
Traktor Cub Cadet C470 Návod k obsluze
(28 stránky)
(28 stránky)
Traktor Cub Cadet RZT 54 Uživatelský manuál
(2 stránky)
(2 stránky)
Traktor Cub Cadet 3165 Uživatelský manuál
(60 stránky)
(60 stránky)
Traktor Cub Cadet 5234D Návod k obsluze
(48 stránky)
(48 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.135 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce