Cub-cadet C-155G Uživatelský manuál

IMPORTANT: Read Safety Rules and Instructions CarefullyOwner’s Manual♦SET-UP ♦OPERATION ♦MAINTENANCEPRINTED IN CANADA OGRM-7004

•Install the mulch plug and secure it inplace with the carriage bolt, cuppedwasher and plastic wing nut as illustratedin Figure 6.•Remove the mulching

NOTE: The deck engagement/lift le-ver must be in the disengaged(BLADES STOP) position when start-ing the engine, when traveling inreverse and if the o

SAFETY INTERLOCK SYSTEMWARNING: Read, understand, andfollow all instructions and warningson the machine and in this manualbefore operating.This tracto

NOTE: If any problems are encoun-tered, refer to the Trouble ShootingChart.•If the blades are engaged, place the deckengagement/lift lever in the BLAD

MOWINGWARNING: To help avoid bladecontact or a thrown object injury,keep bystanders, helpers, childrenand pets at least 75 feet from themachine while

NOTE: Check the tractor’s tire pres-sure before performing any deckleveling adjustments. Refer to Tireslater in this section for further informa-tion

•Remove the hairpin clip which secures thedisengagement rod to the stabilizer shaftassembly. See Figure 10.•Pull the rod toward the rear of the tracto

•Remove the cover panel and locate thespeed control rod. See Figure 14.NOTE: There is a small yellow wire con-nected to a spring switch on the undersi

•Make certain the steering wheel is in posi-tion for straight-ahead travel before againtaking measurements. Continue to repeatthe steps above until a

•Service the oil filter (if so equipped) as in-structed in the separate engine manualpacked with your unit.Perform the above steps in the opposite or-

2TABLE OF CONTENTSCALLING CUSTOMER SUPPORT...2TABLE OF CONTENTS ...2IMP

•Using a spring puller (Part No. 732-0571)orother suitable tool, disconnect the springwhich is attached to a small hook found onthe left, rear portion

CUTTING BLADESWARNING: Be sure to shut theengine off, remove ignition key,disconnect the spark plug wire(s)and ground against the engine toprevent uni

WARNING: Batteries give off anexplosive gas while charging.Charge battery in a well ventilatedarea and keep away from an openflame or pilot light as o

NOTE: On 46-inch decks, you must also re-move both the deck stabilizer bracket andthe stabilizer rod. To do so, remove the hair-pin clip which secures

•Carefully lower the pulley off of the crank-shaft and remove the belt from around it.•Disconnect the battery cables from the ter-minals (disconnect t

ATTACHMENTS & ACCESSORIESThe following attachments and accessories are compatible for Lawn Tractor Models 660-668.See the retailer from which you

TROUBLE SHOOTING GUIDEPROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTIONEngine will notcrank.Safety switch button not de-pressedThere are two switches in the

27THREE (3) YEAR LIMITED WARRANTYFor three (3) years from the date of original purchase of our products, we will either repair orreplace, at its optio

notes . . .31

GENERAL OPERATION•Read, understand, and follow all instruc-tions on the machine and in the manual(s)before attempting to assemble and oper-ate. Keep t

•Disengage blade(s), set parking brake,stop engine and wait until the blade(s)come to a complete stop before removinggrass catcher, emptying grass, un

•Do not try to stabilize the machine by putt-ing your foot on the ground.•Do not use a grass catcher on steepslopes.•Do not mow on wet grass. Reduced

low engine to cool at least two minutesbefore refueling.h. Never over fill fuel tank. Fill tank to nomore than ½ inch below bottom of fillerneck to al

715ºUSE THIS SHEET AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY.A CORNER OF A BUILDINGFOLD ON DOTTED LINE, REPRESENTING A 15oSLOPEO

This owner’s manual covers various models oflawn tractors. The units illustrated may varyslightly from your unit. Follow only those in-structions whic

NOTE: If the openings on each end ofthe steering bellow are two differentsizes, the smaller end goes downagainst the dash of the lawn tractor.•Positio